Whirlpool Washing Machine FP or F9 E1 Error Code
If your washing machine is not working correctly it’s safe to say it's developed a fault. A flashing FP or F9 E1 error code on the LCD display can ring alarm bells, but it’s typically associated with a water draining problem inside the drum.
That’s where eSpares come in! You’ve got the question’s and we’re sure to have the answers. By following our article below we can get you out of this dilemma and see that your laundry pile is back under control again.
Blocked Filter
Most washing machines won’t start a spin cycle until they’ve fully drained the water from the wash.
If your machine is draining very slowly or not at all the most likely cause is a blockage somewhere in the drainage system and the most common is the filter.
Safety First! Please make sure that you have disconnected the appliance from the mains before beginning any repair.
The best way to check if your filter is blocked is to:
- Drain the water from the machine by lowering the drain hose below the water level to a bowl or your machine may have a drain hose near the filter
- Place a towel under the filter and pull the filter out to remove any debris that may have gathered.
- Check the pump impeller inside the housing turns freely and is not obstructed.
eSpares Top Tip: Check your filter as part of your regular maintenance to ensure your washer runs smoothly and ensure no drainage problems.
If the filter is damaged a replacement will need to be fitted, and you can see our extensive range of washing machine filters here within our extensive selection of washing machine spares.
For a more detailed guide on how to diagnose draining and motor problems in your washing machine, watch our helpful video that is sure to aid you in fixing your washer.
Drain Pump
A common draining issue could be caused by a faulty drain pump, which is used to drive and drain the water out of the washer.
If you cannot hear the pump trying to empty the water when you select a drain or spin cycle, then suspect the drain pump is the issue.
Safety First! Please make sure that you have disconnected the appliance from the mains before beginning any repair.
- It's always a good idea to make sure your drain pump is faulty before going ahead and replacing it. That's why we have a guide on how to use a multimeter to test a washing machine drain pump, which will help you determine whether or not the part is actually faulty before removing it and fitting a new one.
If you require a new drain pump, browse our extensive range of washing machine spares for that perfect replacement.
We also offer a guide on how to replace a faulty drain pump; just see our video below for further details.