Hob Burner Ignition Electrode - 900mm Stock Number: ES780261
Genuine spare part for select New World and Stoves cookers
Manufactured by Belling
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Hob Burner Ignition Electrode - 900mm
Replace your damaged part with this genuine spare part for select New World and Stoves cookers, measuring 900mm in length, and get things heating up properly in time for that dinner party.
Specification:
- Length: 900 mm
Please check in the list of appliances to ensure that this part is compatible with your appliance.
4 Questions and 4 Answers
It sparks but the outer casisng is broken and when it sparks it won't ignite
-
Chris at eSpares says...
In order for us to answer your question or source the exact part you require please provide us with the following information: Appliance make, model and serial number of your appliance. For further help visit the "Finding Model Numbers" page on our website here: http://www.espares.co.uk/findingmodelnumbers. Alternatively please copy and paste this link into your web browser.
It is for largest burner on front left
-
Chris at eSpares says...
In order for us to answer your question or source the exact part you require please provide us with the following information: Appliance make, model and serial number of your appliance. For further help visit the "Finding Model Numbers" page on our website here: http://www.espares.co.uk/findingmodelnumbers. Alternatively please copy and paste this link into your web browser.
The hob electrodes click quietly in the back ground but will not always ignite the ring, if I lite the gas with a match and then try again when the ring is hot they will lite, also when hot the click from the electrode is louder. The electrode is attached to the chassis via a teardrop shaped bracket held in place with one screw, is there a insulator/gasket between the chassis and electrode bracket that is breaking down ? Comments please and item codes of any parts required. Thanks.
-
Chris at eSpares says...
The first thing to do is clean all the electrodes and if one ring is poor to lite then swap its electrode over with another.If this transfers the problem replace the faulty electrode. If all are poor to light try disconnecting one electrode at a time to see if this identifies a faulty electrode.
my igniter carries on "sparking" after the gas on the hob has ignited . will a new electode for each burner solve the problem ? 1 Answer
-
Chris at eSpares says...
It is likely that replacing the electrodes will cure your problem but this is not guaranteed. Some times it is impossible to be sure of a fault without substituting components.
Will this part fit my appliance?
Check Now
