Vacuum Cleaner Brushbar Assembly Stock Number: ES1085028
Genuine spare part for all models of Dyson DC24 vacuum cleaners
Manufactured by Dyson
(This part fits select models)
Will this part fit my Appliance?
Check this part fits your appliance
Will this part fit my Appliance?
This product is compatible with:
- Dyson DC24 Vacuum Cleaners
Vacuum Cleaner Brushbar Assembly
This brushroll is made of tough ABS plastic with long nylon brushes to ensure good deep cleaning when you vacuum. Replacing a damaged brush roll will improve the performance of your vacuum cleaner. So if yours is tangled up with hair or generally worn then pick up this genuine Dyson spare!
Fits all models in the following Dyson vacuum cleaner ranges:
- DC24
Please check the list of suitable models to ensure that this spare part will fit your appliance.
Dyson spares reference: 917390-01
6 Questions and 7 Answers
The 3 rubber prongs on the in side of the brush bar has worn away if I replace it will the brush turn again?
- If the brush motor is still running then it is the moulded threads but if the brush motor is not running then it is most likely the filters need changing.
- The molded "threads" on the inner side of the end cap that retains the brush bar are easily damaged (usually by trying to remove it without turning it 90 degrees). This allows endways movement of the bar. This extra clearance causes the drive to slip and the drive prongs wear away the corresponding brush bar "prongs" you mention. A new bar will therefore quickly wear the same way without a new end cap.
-
Chris at eSpares says...
We are sorry but do not have any dimensions for this product. It is likely the bristles will wear and if used a lot we would suggest replacing it.
The housing in the end cap has fractured and brush bar vibrating badly. Replaced end cap but it fractured again. Suspect brush bar may be slightly distorted due to initial end cap damage but would welcome any advice. 1 Answer
Developed a strong vibration from the brush bar area. Found that the housing on the left side end cap (looking from the back of hoover) which fits into the brush bar had fractured. Replaced the end cap and cleaned out the end of the brush bar, albeit the end was rather rough I suspect due to the previously mentioned damaged. Whilst the end cap did turn when fitted onto the brush bar it certainly did not swing freely as shown on the Dyson replacement video. After hoovering half a room the vibration returned and examination revealed that the housing on the end cap had sheared again. Before I purchase a new brush bar and another end cap am I on the right lines or is there some other issue I am not picking up on? Grateful for any advise you can give me
-
Chris at eSpares says...
It sounds like the brush spindle may be damaged and if this has resulted in the moulding that located the bearing becoming worn and loose if this is not repaired as well the problem is likely to return. Examine and replace any worn damaged or suspect parts to prevent the chance of future failure.
my dc 24 all floor brush bar is noisey when it spins round is it the little bearings that is to blame 1 Answer
-
Joshua at eSpares says...
If the brush bar is especially worn or if there's anything wrapped round out (such as hair or carpet fibres) then it can cause problems and noise, so take a look. If your vacuum is also producing a burning smell during use then it could be a problem with the motor - check out our video on how to replace it.
Will this part fit my appliance?
Check Now
